Copper aluminum radiator manufacturers introduce f

2022-07-22
  • Detail

Many consumers don't know much about the water inlet method of radiators. In fact, the water inlet method of installing radiators is very important for the goose connection of radiators. Now I will introduce several ways of radiator water inlet connection

many consumers don't know much about the water inlet mode of radiators. In fact, the water inlet mode of installing radiators is very important for the goose connection of radiators. Now I will introduce several ways of radiator water inlet connection

opposite side up in and down out

this connection method is the most reasonable and conducive to water circulation. This is the most common connection method in Europe. The water supply temperature of all radiators is equal. In this connection method, a balance angle valve needs to be installed at the outlet of each radiator. Through the adjustment of the balance angle valve, the flow of radiators close to the water pump is too large, and the flow of radiators far away from the water pump is too small

same side up in and down out

this form is very similar to the opposite side up in and down out. The biggest advantage is that there is a good water circulation, which increases the flow speed of the water flow and increases the inlet and outlet. But correspondingly, this kind of radiator also needs to increase the length of the pipe, which is very inconvenient and brings some trouble to the family. Although the heating effect is very good, it is not beautiful

bottom in and bottom out

it can not only keep the overall shape of the radiator from being damaged, but also save materials to the greatest extent. Because the water inlet and outlet are below, the connection and laying of water pipes are also very convenient. Moreover, after the radiator is installed, users can drain and exhaust manually, which is very convenient. At present, most of the more popular steel radiators in the market choose this way of water inflow and outflow, which can save space to the greatest extent, maintain the beauty of the radiator, and also more in line with the aesthetic outlook of modern people

bottom in bottom out

now basically all newly built residential areas are connected in this way, and the heating pipes are laid on the ground inside the house. When making radiators, radiator manufacturers need to set a diaphragm inside the radiator near the water inlet, so that the water flow is forced to circulate inside the radiator. This way of water inlet and outlet is most suitable for central heating. If it is independent heating, it is best not to adopt this way, because it will affect the water circulation and indirectly lead to the unsatisfactory heating effect

copper aluminum radiator: http://www.ksgl2008.com/

top ten rankings of radiators: http://www.ksgl2008.com/ProductView.asp?ID=560& ; SortID=184

合肥牛皮癣医院

郑州不孕不育医院

昆明男科医院

贵阳风湿医院

Copyright © 2011 JIN SHI