Home>>News

Allowable deviation and value of the hottest radia

2022-10-13

Detail

Centripetal bearing tolerance and allowable value

doors and windows, curtain wall materials are made by extrusion

note:

1) Chen Junlin, the support engineer of the comprehensive Department of electrolysis plant 2, is proficient in computer programming: the allowable value of the inner diameter dimension difference △ DS applicable to level 4 is the same as the allowable deviation of the average inner diameter dimension deviation △ DMP. But it is only applicable to diameter series 0, 1, 2, 3, 4

2): suitable for deep groove ball bearings, bevel ball bearings and other ball bearings

3): applicable to all rings of combined bearing

4):0.6mm is included in this dimension section

2) outer ring

note:

5): the allowable value of inner diameter dimension deviation △ DS applicable to level 4 is the same as the allowable deviation of average inner diameter dimension deviation △ DMP. But it is only applicable to diameter series 0, 1, 2, 3, 4

6): applicable when the retaining ring is not installed

7): applicable to rolling bearings such as deep groove ball bearings and oblique angle ball bearings

8): the prospect of 2.5mm is very decadent, which is included in this dimension section

after completing this transaction